• Havoc
  • Caius
  • redboot
  • Rules
  • Chain of Command
  • Members
  • Supported Ladders & Games
  • Downloads


W10 Direct-Play for Wolfpack
01-17-2020, 12:31 PM,
#1
W10 Direct-Play for Wolfpack
Good Evening:

   Anyone have  any advice for playing wolfpack using direct-play?  What port assignments should be used etc?  We used to play Jutland all the time.

Regards,
Quote this message in a reply
01-18-2020, 11:50 AM,
#2
RE: W10 Direct-Play for Wolfpack
Got a little help from JTS support and I played 1 on 1 in the getting started scenario. Got a down the throat shot on a CGC after it had collided with the corvette it was hunting me with. Didn't sink and AK but managed to damage a few with my deck gun. Finally ran away as I was out of fish and was losing the gun battle with the Corvette. We are both vets of the Naval Battles but haven't played them in a long while. We had a blast. Big Grin
Quote this message in a reply
01-19-2020, 01:05 AM,
#3
RE: W10 Direct-Play for Wolfpack
Hey Phil (and I'm guessing Rich!)!

Would you be interested in drafting up a quick "How To" and posting over at the Naval Warfare forum? Might save some time for other players ... ... ... like me!
Quote this message in a reply
01-19-2020, 01:04 PM,
#4
RE: W10 Direct-Play for Wolfpack
This is what Rich put up on the FB group:

Quote:If anyone tries to connect on-line, the key is opening the right ports on your firewall - be it a software or hardware firewall. The ports you need to have open are:
47624 to 47624
2300 to 2400
6073 to 6073 I always did this for both TCP & UDP traffic.
Scenario Designer JTS Midway JTS Seven Years War
Quote this message in a reply


Forum Jump:


Users browsing this thread: 1 Guest(s)